Updating boot support partitions for the volume as
Systems must map keys to the following ACPI notification values: Windows 10 for desktop editions (Home, Pro, Enterprise, and Education) x64 Windows 10 for desktop editions (Home, Pro, Enterprise, and Education) x86 Windows 10 Mobile ARM Windows 10 Mobile x86 Windows Server 2016 x64 Description This requirement is currently optional and will not be enforced until 2017. If the integrated camera is a USB camera, it must also comply with Device. This origin is relative to the native pixel addressing in the display component. In addition, systems that support connected standby must: NOTE: For systems that require a separate driver to handle power button presses, it is acceptable to have that driver evaluate a control method that performs a Notify() on the Control Method Power Button device instead of using the GPIO-based solution above.
Hardware buttons must be implemented according to the guidance on the following page: https://msdn.microsoft.com/en-us/library/windows/hardware/dn957423GPIO buttons must be specified using the standardized ACPI generic button device (ACPI0011): https://msdn.microsoft.com/en-us/library/windows/hardware/dn957422In the case where buttons are not wired through GPIO interrupts, buttons must be reported to Windows as HID collections. The origin is the lower left hand corner of the display, where positive Horizontal and Vertical Offset values are to the right and up, respectively. Button Array-based Power Button Touch-first (keyboard-less) systems must: NOTE: For systems that require a separate driver to handle power button presses, it is acceptable to have that driver call the 5-Button array driver's power button event interface instead of using the GPIO-based solution above.
When the pixels read out from the camera sensor can be displayed correctly without any rotation, then the camera sensor’s _PLD rotation value must be set to 0. Any system that supports Connected Standby that sets the "CMOS RTC Not Present" bit in the IAPC_BOOT_ARCH flags field of the FADT must implement the device's Time capabilities.
The Off state is defined, at a minimum, as disabling the antenna component of the Bluetooth enabled module so there can be no transmission/reception. Description Support for Wi-Fi Direct by the Wi-Fi Driver to enable Miracast, Public APIs for Wi-Fi Direct to allow pairing to & from the PC, Accepting and Connecting to other Wi-Fi Direct Device for the GO & the Client Role.
There must not be any hardware-only switches to control power to the Bluetooth enabled radio. This includes support for concurrent operation over Wi-Fi Direct & Station.
The radio can be completely powered off if a bus-supported method is available to turn the radio back on. Resolution requirement for full requirement details. Description The following Pen device level requirement must be met and verified upon integration into a system. Devices must report support for Hang Detection and Recovery in WDI_GET_ADAPTER_CAPABILITIES.
No additional vendor software control components will be supported. Please refer to the WDI Spec for implementation details.